Your Cart:
0 Items
Order Total: $0.00

0 Product
$0.00




Eleven Tips for Adjusting a Furnace Gas Valve PDF Print E-mail
Written by Administrator   
Friday, 25 June 2010 13:02
AddThis Social Bookmark Button

A high gas valve provides gas oven burners. This gas is flammable provided once the burners heat up enough to allow combustion. Here are some tips from eleven to help you adjust a valve gas oven.
One. Check pressure

It is recommended that you do not adjust your furnace at a pressure other than that recommended by your manufacturer.
2. Follow the procedure of law

The button that controls the valve must be set to "ON". Thermostats required should be established so that fires burning. The pressure on the gauge should be checked. To make adjustments, the CAP, which covers the screw of the pressure regulator should be placed and removed. You can then make adjustments to the pressure in the position up or down.
3. Check pilot

If your device does not produce heat at all it might be because your driver must be rekindled and the gas valve is not open. In some cases, the thermostat may not work correctly. Verify that the pilot valve.
4. Call for help

If your gas furnace does not work, instead of trying to adjust the gas valve of a furnace, call a technician to know what is the problem.
5. Crosslight Clean

If several burner tubes before adjusting the burner, remove the burners and make sure you clean the Crosslight.
6. Adjust regulator

Very often, the gas pressure is too low. This could be because the gas valve or the regulator can not be properly adjusted. Following this fire which is the condition is dangerous and inappropriate. This problem can be corrected by adjusting the regulator. You should however know what the problem is caused. Stimulating the pressure at the valve is not recommended because it can be dangerous.
7. Settings ensure the best

For your heating system to heat effectively you must make sure they can be resolved fairly well for it to operate continuously even in the coldest weather.
8. Adjust the gas flow

The gas flow can be adjusted using a screw located under the large screw or screw cap. By turning the screw which is available for the left driver adjustment, the flame can be increased.
9. Set pressure

If you turn the screw clockwise give it more pressure. Similarly, it rotates anti clockwise give less pressure. When you try to make these adjustments yourself, make sure you do not turn the screw more than ¼ turn or another.
10. Check sequence

Check the sequence followed by the oven right from the moment he begins to understand if you have a gas valve defective. Do not adjust the valve if you hear a "hissing" while trying to light the gas.
11. Keep the ballpark

The amount of gas that goes to your heater should be allowed to vary from anything between 40 and 100 per cent. This will help save energy.

 
The tab is closed
The tab is open